In this video I show how to configure a client to site IKEv2/IPSec tunnel on a Cisco ISR router using Certificates for authentication, as well as configuring Cisco AnyConnect on the client PC.
In this video I will walk you through configuring a very simple VPLS lab using 3 provider routers and 3 customer edge routers.
There are a few different ways you can implement provider redundancy in your network. You could terminate all ISPs into a single router using traditional ip sla + track. You could terminate the ISP connections on different routers, or even have a router per ISP – a 1:1 ISP to router ratio. The last method…
Read more
In this video I go over the basics of Cisco EVN and also provide a sample lab configuration.
Confused as to how to redistribute a default route into BGP? I know, in most IGPs this is accomplished with “default-information originate”, however BGP is a little different. This video will show you the 3 different ways to advertise a default route into BGP on a Cisco router and the difference between each of them.
In the video I briefly touch on the concepts of Q-in-Q as well as provide a sample configuration.
In this video I show how to configure a pair of Cisco ASA firewalls for Active/Standby Failover.
What Is Proxy ARP? I hope to answer that for you in this short video!
In this video I go over the basics of spanning tree protocol which covers what you are expected to know for CCNA.
This video shows how to configure a client to site IKEv1 IPSec VPN tunnel on a Cisco ISR router
Recent Comments